I have BIGAVR2 development board. For some reason I can not use built in programmer and want to use USBASP programmer. Then I connected my USBASP programmer directly to MCU board (mega128 by soldered wires) to appropriate pins. Unfortunately my software does not recognize microprocessor. Programmer USBASP is working on another development board so is fine, connections was checked few times and no faults found, microprocessor on MCU card is ok (because I can see on leds that last program is executing). Signal clock is from oscillator. What I have done wrong ?.
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum